Different between 3 plate & 2 plate mould design 3 plate mould here is two cavity with 4 pcs pin-point gate, and 2 plate mould is one cavity, offset spruce mould and edge gate. Product Details: Product name: X61A1846 Industries: Industrial Mold Standard: HASCO Steel: S136 HRC 50-54 Cavities 1 x…
offset spruce mould design
Offset spruce mould design is usual for 1 cavity single mould, when it is edge gate not direct gate with submerge. Product Details: Product name: X61A1846 Industries: Industrial Mold Standard: HASCO Steel: NAK 80 HRC 38-42 Cavities 1 x 1 Plastic: PA6+30%GF Runner system: Cold Cycle time: 55s Gate: edge Mold…
slider change part line
Slider change part line Slider solution is most use for mould release, it could be used to change part line too, in order to get better look and better assembly. 1.Part and Part line 2.Part and Part line
what is kiss off & shut off?
What is kiss off & shut off? Some guys are confusion for kiss off & shut off in mould design. The key is to see core and cavity, it will be kiss off if they kiss each other(Mouth to mouth), and it will be shut off if they brush past(Side…
12 cavity family mould design
12 cavity family mould design Family mould is popular in plastic injection mould making, it is usually for small parts, any quantity parts make in one mould is OK. It usually makes mould for toys or other not precision parts. 1. Part Drawing 2. Mould structure 3. Moulded parts 4.…
MUD mould design
MUD(Master Unit Die) Mould Design MUD mould is a standardized general mold structure, usually small products, mold parts are common, only replace the mold core part, simple structure, low cost, also known as fast die change. 1. Part Drawing 2. Mould structure 3. Moulded parts 4. Mud mould making
ejector pin on slider-CAMS
Ejector pin on slider/CAMS for mould design This is project is very reference value, as there are ejector pin on slider-CAMS, Cooling on slider, Tunnel Slider on slider.
